Category » Z-Vent Dimensions

There were 21 questions found in this category:

1. Adjustable Length
   Cinnabar Equipment Co. http://www.ventingstore.com
2. 90 Degree Elbow
   *The Z-Vent 90 degree and 45 degree elbows are all non-adjustable,rigid elbows. * Inner Gasket on the female end, non-gasketed male * In many cases, a 90 degree elbow will have the value of 5 feet against your maximim length of pipe run.Also, some appliance manufacturers limit the number of elb ...
3. Hi-Temp RTV Sealant
   Temperature Rating: -62 to +500 Degrees F. For use inside the Storm Collar before clamping, minimizes rain water from trickling down the outside of the pipe. Also used on the back of a flush mounted Termination to keep moisture from entering behind the Termination. Not to be used when joining ...
4. 45 Degree Elbow
   * Z-Vent 45 degree and 90 degree elbows are non-adjustable, rigid elbows. * Inner gasketed female and non-gasketed male * In many cases, a 45 degree elbow will have the value of 2.5 feet against your maximim length of pipe run. Check your manufacturers installation manual for their venting req ...
5. Vertical Condensate Drain Tee
   Cinnabar Equipment Co. http://www.ventingstore.com
6. Z-Vent Termination Hood with Damper
   Used for exhaust venting only, not for use as a fresh air intake. A bird screen is factory installed. Cutable extension. Made of AL29-4c stainless steel.
7. Termination Hood
   Cinnabar Equipment Co. http://www.ventingstore.com
8. Roof Assembly Picture
   Final Roof Assembly
9. Extended Wall Thimble
   The Wall Thimble in 3 Inch diameter requires a 7 inch round hole for installation and a 4 inch diameter thimble requires a 8 inch round hole for installation.This will provide the correct clearance to combustibles. Cinnabar Equipment Co. ...
10. Wall Thimble
    The Wall Thimble in 3 Inch diameter requires a 7 inch round hole for installation and a 4 inch diameter thimble requires a 8 inch round hole for installation.This will provide the correct clearance to combustibles. Cinnabar Equipment Co. ...
11. Horizontal Condensate Drain
    Cinnabar Equipment Co. http://www.ventingstore.com
12. Z-VENT CONDENSATE DRAIN,ADAPTER,BACKFLOW: 3 IN 1 FOR 4 Inch Venting
    Z-Vent Part # 2SVBFDPA04 10 3/4 inches high Appliance Adapter,Condensate Drain and Backflow Prevention Built into one piece. Mounts on top of the Appliance in a Vertical position. Condensate Starter Hose shown in photo is sold sep ...
13. Universal Appliance Adapter
    The Bosch Tankless models 250, 2400 and 635 series do not require an Appliance Adapter and requires our Z-Vent 3 inch diameter vent pipe. The Bosch Tankless model 250 does require our 4 inch diameter Z-Vent pipe as well as an Appliance Adapter. Takagi, Noritz, Paloma and Rheem do require an app ...
14. Termination Tee
    Cinnabar Equipment Co. http://www.ventingstore.com
15. Termination Box
    Cinnabar Equipment Co. http://www.ventingstore.com
16. Roof Flashings
    Cinnabar Equipment Co. http://www.ventingstore.com
17. Rain Cap
    Installations also requires the use of a Storm Collar in addition to the Rain Cap. Cinnabar Equipment Co. http://www.ventingstore.com
18. Paloma PTG-42 + Rheem RTG-42 Appliance Adapter
    Cinnabar Equipment Co. http://www.ventingstore.com
19. Firestop Support
    Cinnabar Equipment Co. http://www.ventingstore.com
20. Condensate Drain:Vertical In-Line
    * Dimensions: 3 inch diameter pipe = 8 inches high 4 inch diameter pipe = 8 inches high * Suggested placement is closest to the exhaust on the heater * Inner Gasketed female and non-gasketed male * Hi-Temp starter Condensate Hose is required and avail ...